The AW-CFP2166 series conventional fire alarm panel is designed based on EN54 part 2＆4 standard. And it is the central part of a conventional fire alarm system, designed for applications requiring a smoke detector, bell, manual pull stations, and sprinkler.
4 Zone Fire Alarm Control Panel Specification
1. It is a modularized design, the panel can expand from 1 zone to 32 zones easily.
2. It has 2 level control mode by a lock
3. It has 24VDC and 5VDC power supply output.
4. It has FIRE and FAULT signal output.
5. It has 2 general sounders output.
6. Each zone has 1 circuit detectors input
7. Each zone can be disabled by a button.
8. It has a RESET button to reset the panel.
9. It has a SILENCE button to stop BUZZER and SOUNDERS.
10. It has EVACUATE button to start a manual fire alarm immediately.
11. It has a battery low protection function when battery voltage lower than 21VDC
the battery will be cut off automatically until the mains power is on.
12. It has an optional GSM module for fire alarm by SMS
Technical parameters
AC INPUT
220VAC 50HZ
10%
-15%
DC OUTPUT
24VDC typical
Voltage for MCU
5V for power board MCU, 3.3V for others
Current at 24VDC from PSE
450mA standby current
Maximum current from PSE
2A except batteries charge
Batteries current
1.85A maximum, current limited
Auxiliary output
24VDC /- 10%, 100 mA max,
current limited, monitored
Batteries
2*12V/ 2.3Ah sealed lead acid gel,
self-regulated
2*12V/ 7Ah if needed
Battery replace Resistance
2Ω±10% if needed
Battery low-voltage protection
22.2V
Detectors connection allowed each zone
20 (except MCPs)
Zone alarm current
6mA minimum/ 27mA maximum
Sounder output
2*0.75A maximum
Fire protection
100mA maximum
Fire routing
100mA maximum
Fault routing
100mA maximum
Communication protocol
2 wires RS485 bus system
Relay contacts rating
Dry contacts (NO/NC) 1A @24VDC
EOL resistor for zone
6.8K 1W
EOL resistor for outputs
6.8K 1W
Fuse on power board
3A/ 250V glass tube fuse 20mm
Fuse on EMI board
1A/ 250V glass tube fuse 20mm
Environmental
Class A temperature range: -5 to 40°C (23~104°F)
Humidity: 5 to 95% RH, non-condensing
Terminal blocks rating
All terminals rated for 12 to18 AWG
(0.75 to 2.5 mm2)
Visit our shop today (Informed Systems Limited, Uniview Distributors)at Kamae road, off Luthuli Ave, or contact @0745765503.
There are no reviews yet.