Asenware Conventional Manual Call Point AW-D135C

The AW-D135C Conventional manual call point is designed to be use with an intelligent two-wire control system. If it is pressed after a fire is manually confirmed, an alarm signal may be sent to a fire alarm control system which will, after receiving the alarm signal, display the equipment status of the manual fire call points. When the manual fire call points is operating normally, the red indicator will blink; when there is a fire alarm, it will remain lit.

This passage will introduce the features, installation, wiring and use of AW-D135C conventional manual call point, to help you understand more about the conventional manual call point.

The AW-D135C conventional manual call point can be semi-recessed or mounted on the wall surface. When installing, this manual call point has to be installed in the order of base, middle cover, and top cover. Fix the base on the wall, then attach the middle cover to the base, and finally attach the top cover to the middle cover.

The size of the base is 87mm×7mm×33mm (L×W×H), the mounting hole diameter is φ5mm, and the fixed hole spacing is 36mm.

1.Activation

When a fire occurs, press the button in the middle of the manual call point, then the manual call point will send a fire signal to the fire panel, and the LED indicator will be on.

2.Reset

After the manual call point is done using, it is necessary to reset it with the reset key, so that the conventional manual call point can be in a normal state again and get ready for the next use.